3. Inside the black circle, locate the small round glass bubble level.
4. Turn the scale feet clockwise to adjust the them in the opposite direction to which the bubble is
leaning.
Note: Always adjust the two feet on a side together to prevent the scale from rocking.
5. When the bubble is level, push down on all four corners of the scale to make sure each foot is
touching the table.
6. Replace the top cover.
7. Check the scale with a known item. (Note: US Quarters weigh .2 oz. each and are a good test.)
Re-zero the scale:
Refer to refer to Zeroing the scale.
Check the USB cables:
1. Tap the Home icon.
2. Disconnect the USB cable from the back of the scale.
3. Wait five seconds, then re-connect the USB cable.
4. Unplug the USB cable from the back of the meter.
5. Wait five seconds, then re-connect it both ends.
6. Check the scale with a known item. (Note: U.S. Quarters weigh .2 oz. each and are a good test.)
Troubleshooting
Pitney Bowes Operator Guide June 2018 205
To Next Page
Loading...
