Planet FGSD-1022P - State Activity

User’s Manual of FGSD-1022 Series
4.6.3 State Activity
Having set up the LACP aggregator on the tab of Aggregator Setting, you can configure the state activity for the members of
the LACP trunk group. You can tick or cancel the checkbox beside the state label. When you remove the tick mark of the
port and click
Apply
, the port state activity will change to
Passive
.
Figure 4-6-7: State Activity of Switch 1
The page includes the following fields:
Object Description
Active: The port automatically sends LACP protocol packets.
Passive:
The port does not automatically send LACP protocol packets, and responds only
if it receives LACP protocol packets from the opposite device.
A link having two passive LACP nodes will not perform dynamic LACP trunk because both
ports are waiting for an LACP protocol packet from the opposite device.
105