Planet FGSD-1022P - System Commands

User’s Manual of FGSD-1022 Series
157
6.1.2. Command Help
You may enter ? at any command mode, and the CLI will return possible commands at that point, along with
some description of
6.2 System Commands
show running-config
Description:
Display the running configuration of the switch.
copy running-config startup-config
Description:
Backup the switch configurations.
erase startup-config
Description:
Reset to default factory settings at next boot time.
clear arp
Description:
<ip-addr> specifies the IP address to be cleared. If no IP address is entered, the entire ARP cache is cleared.
show arp
Description:
Show the IP ARP translation table.
ping
Description:
Send ICMP ECHO_REQUEST to network hosts.
Parameters:
<1..999> specifies the number of repetitions. If not entered, it will continue to ping until you press <Ctrl>-C to stop.