User’s Manual of FGSD-1022 Series
209
poe priority
Description:
Set port priority for the power supply management.
The command is configurable while “poe limit-mode” is set to “Port Priority”
Command Level:
Global Configuration
Syntax:
poe priority { Critical | High | Low} [<port-list>]
Parameters:
{Critical | High | Low}
Critical — Indicates that operating the powered device is high.
High— Indicates that operating the powered device has medium priority.
Low— Indicates that operating the powered device has low priority
<port-list> specifies the ports to be set. If not entered, all ports are set.
Example:
Switch(config)# poe priority low 1
Switch(config)# show poe status 1
Port Admin Oper
Power
Mode
Priority Power Limit[W]
Current Consumption
[W]
Current[mA] Device Class
Port1 Enable on 802.3at
Low
15.4 13.4 279 0
poe maximum-power
Description:
Enabling or disabling per port power output limit. (FGSD-1022P only)
The command is configurable while “poe limit-mode” is set to “Total-Limit”
Command Level:
Global Configuration
Syntax:
poe maximum-power <1~15.4> [<port-list>]
no poe mximum-power [<port-list>]
Parameters:
<1~15.4>
<port-list> specifies the ports to be set. If not entered, all ports are set.
To Next Page
Loading...
Need help?
General
