Planet FGSD-1022P - Port Rate; Port Jumboframe; Show Port Status

User’s Manual of FGSD-1022 Series
159
port rate
Description:
Set port effective ingress or egress rate.
Syntax:
port rate <ingress | egress> <0..8000> [<port-list>]
Parameters:
<0..8000> specifies the ingress or egress rate.<0..8000>
<port-list> specifies the ports to be set. If not entered, all ports are set.
port priority
Description:
Set port priority.
Syntax:
port priority <disable | low | high> [<port-list>]
Parameters:
<port-list> specifies the ports to be set. If not entered, all ports are set.
port jumboframe
Description:
Set port jumbo frame. When port jumbo frame is enable, the port forward jumbo frame packet
Syntax:
port jumboframe <enable | disable> [<port-list>]
Parameters:
<port-list> specifies the ports to be set. If not entered, all ports are set.
show port status
Description:
Show port status, including port State, Link, Trunking, VLAN, Negotiation, Speed, Duplex, Flow control, Rate
control ,Priority, Security, BSF control.
Switch(config)# show port status
----------------------------------------------------------------------
Port 1 Information
----------------------------------------------------------------------
State: on
Link: down
Trunking: none
VLAN: DEFAULT
Priority: disable
Security: off
----------------------------------------------------------------------