User’s Manual of FGSD-1022 Series
Example:
Switch(config)# poe maximum-power 10 1
Switch(config)# show poe status 1
Port Admin Oper
Power
Mode
Priority Power Limit[W]
Current Consumption
[W]
Current[mA] Device Class
Port1 Enable on 802.3at Low
10
00 0
poe maximum-power
Description:
Enable per port power output limit
The command is configurable while “poe limit-mode” is set to “Total-Limit”
Command Level:
Global Configuration
Syntax:
poe maximum-power <0~308> [<port-list>]
Parameters:
<0~308> <802.af>power limit range from 0~15.4, <802.at>power limit range from 0~30.8, the set value must multiple of
10 (FGSD-1022HP only)
<port-list> specifies the ports to be set. If not entered, all ports are set.
1. This PoE maximum-power command has included in FGSD-1022HP only.
Example:
Switch(config)# poe maximum-power 100 1
Switch (config)# show poe status 1
Port Admin Oper
Power
mode
Priority
Power
Limit[W]
Consumption [W] Current[mA]
Device
Class
Port1 Enable on 802.3af Low
10
00 0
210
To Next Page
Loading...
Need help?
General
