CLUTCHING
4.29
Installation, Cont.
4. Slide clutch fully onto crankshaft taper.
5. Install retaining bolt with any spacers, washers or
O-rings. See appropriate parts manual for type and
placement of retaining bolt components.
6. Torque retaining bolt to specifications. Hold clutch
with strap wrench.
NOTE: Re-torque clutch to specification after first peri-
od of operation (such as a test ride).
Drive Clutch Bolt Torque (14mm / 7/16s):
50 ft lbs. (69 Nm)
Enfocus Software - Customer Support
To Next Page
Loading...
