ELECTRICAL
8.20
TPS Adjustment
1. Loosen the two screws that hold the TPS on the
carburetors using a Torxt T25 bit with tamper
resistant hole in bit.
2. Turn the TPS clockwise to decrease voltage, or
counterclockwise to increase voltage.
3. When the TPS is set to the desired voltage, tighten
the holding screws and verify voltage is 4.0 --4.2
volts
at Wide Open Throttle
for Polaris domestic
engines.
Decrease
Increase
Enfocus Software - Customer Support
To Next Page
Loading...
