ENGINE
2.59
Oil Pump Drive Gear End Play Adjustment - Fuji
2. Measure distance from oil pump mounting flange
surface to end of seal flange as shown. Call this
measurement “B”.
3. Subtract measurement “B” from “A” to determine
total bushing end play.
4. Measure thickness of existing shims and subtract
from total bushing end play determined in step 3.
5. Add or subtract shims as required to provide
specified end play.
6. Lightly grease a new O-ring and install it on the
pump. Install pump, engaging slot in shaft with drive
gear. Apply Loctite¥ 242 to bolts and torque evenly
to 78 in. lbs. (9 Nm).
Measurement A
Measurement B
Oil Pump Mounting Bolt Torque
(242 Blue)
78 in. lbs (9 Nm)
Optional Shims:
PN 3083671 = .006s(.15mm)
PN 3083672 = .012s (.3mm)
PN 3083673 = .024s (.6mm)
End Play
.008 - .016s (.203 - .406 mm)
Enfocus Software - Customer Support
To Next Page
Loading...
Need help?
General
