EasyManuals Logo

Polaris 2008 sportsman 800efi User Manual

Polaris 2008 sportsman 800efi
388 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #120 background imageLoading...
Page #120 background image
4.4
FUEL INJECTION
Service Notes
• For more convenient and accurate testing of EFI components, it is recommended dealers utilize the Polaris Diagnostic
Software (dealer only), or testing may be done manually using the procedures provided.
• 80% of all EFI problems are caused by wiring harness connections.
• For the purpose of troubleshooting difficult running issues, a known-good ECU from another Polaris ATV EFI of the same
model may be used without damaging system or engine components.
• Never attempt to service any fuel system component while engine is running or ignition switch is "on."
• Cleanliness is essential and must be maintained at all times when servicing or working on the EFI system. Dirt, even in
small quantities, can cause significant problems.
• Do not use compressed air if the system is open. Cover any parts removed and wrap any open joints with plastic if they will
remain open for any length of time. New parts should be removed from their protective packaging just prior to installation.
• Clean any connector before opening to prevent dirt from entering the system.
• Although every precaution has been taken to prevent water intrusion failure, avoid direct water or spray contact with
system components.
• Do not disconnect or reconnect the wiring harness connector to the control unit or any individual components with the
ignition "on." This can send a damaging voltage spike through the ECU.
• Do not allow the battery cables to touch opposing terminals. When connecting battery cables attach the positive (+) cable to
positive (+) battery terminal first, followed by negative (-) cable to negative (-) battery terminal.
• Never start the engine when the cables are loose or poorly connected to the battery terminals.
• Never disconnect battery while engine is running.
• Never use a battery boost-pack to start the engine.
• Do not charge battery with key switch "on."
• Always disconnect negative (-) battery cable lead before charging battery.
• Always unplug ECU from the wire harness before performing any welding on the ATV.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polaris 2008 sportsman 800efi and is the answer not in the manual?

Polaris 2008 sportsman 800efi Specifications

General IconGeneral
BrandPolaris
Model2008 sportsman 800efi
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals