2.31
MAINTENANCE
2
Tire Pressure
Tire Inspection
• Improper tire inflation may affect ATV
maneuverability.
• When replacing a tire always use original equipment
size and type.
• The use of non-standard size or type tires may affect
ATV handling.
Tire Tread Depth
Always replace tires when tread depth is worn to 1/8, (3 mm) or
less.
Frame, Nuts, Bolts, Fasteners
Periodically inspect the torque of all fasteners in accordance
with the maintenance schedule. Check that all cotter pins are in
place. Refer to specific fastener torques listed in each chapter.
Front / Rear Storage Compartments
The front and rear storage (Sportsman Only) compartments are
easily accessible. To open the front compartment turn the latch
handle to the horizontal position on both sides. To close the
storage compartment turn the latch handles to the vertical
position.
CAUTION
Maintain proper tire pressure. Refer to the warning
tire pressure decal applied to the vehicle.
Table 2-1:
TIRE PRESSURE INSPECTION (PSI - COLD)
Front Rear
55
WARNING
Operating an ATV with worn tires will increase the
possibility of the vehicle skidding and possible loss
of control.
Worn tires can cause an accident.
Always replace tires when the tread depth
measures 1/8inch (.3 cm) or less.
Tread Depth - 1/8” (3 mm)
Front Storage - Unlatched
Front Storage - Latched
Sportsman Rear Storage -
To Next Page
Loading...
