2.11
MAINTENANCE
2
Lubrication / Grease Points
* Perform more often under severe use, such as operation in water and under severe loads.
î™®Semi-annually or 50 hours of operation 9refer to Maintenance Schedule for additional information). More often under severe
conditions (operating in water or hauling heavy loads.
Annually or 100 hours of operation (refer to Maintenance Schedule for additional information). More often under severe
conditions (operating in water or hauling heavy loads.
î™°Grease conforming to NLGI No. 2, such as Polaris Premium All Season Grease, Conoco Superlube M, or Mobilgrease Special
#I
TEM LUBE METHOD
FREQUENCY*
1. Engine Oil Polaris 2W/50
Check dipstick and add to
proper level.
Change after 1st month, 6 months, or 100
hours thereafter; Change more often (25-50
hours) in extremely dirty conditions, or short
trip cold weather operation.
2. Transmission
Polaris AGL Synthetic
Gearcase Lube
Add lube to bottom fill hole.
Change annually

3A.
3B.
Front Gearcase
ADC Fluid
Demand Drive LT
Premium Hub Fluid
Polaris ADC Hydraulic
Drain as directed.
Add specified quantity.
Gearcase - Change annually

ADC - Change fluid every 2 years
4. Rear Gearcase ATV Angle Drive Fluid
Drain completely. Add lube to
specified quantity.
Change annually

5. Brake Fluid Polaris DOT 4 Brake Fluid
Fill master cylinder reservoir
to indicated level
As required, change fluid every 2 years
6. Front A-Arm Polaris All Season Grease Locate fitting and grease.
Semi-annually
î™®
7. Rear A-Arm Polaris All Season Grease Locate fitting and grease
Semi-annually
î™®
5. Front Propshaft
Polaris U-Joint Grease
î™°
Locate fitting and grease.
Semi-annually
î™®
1. Engine Oil
2. Transmission Fluid
4. Rear Gearcase
3. Front Gearcase
5. Brake Fluid
6. Front A-Arm
7. Rear A-Arm
8. Front Propshaft
To Next Page
Loading...
Need help?
General
