Poly CCX - Start Video During a Call; Stop Sending Video During a Call; Video Call Settings; Set the Call Rate for Video Calls

Start Video During a Call
If you start a video-enabled call with your camera off, you can turn it on during the
call.
■
On the active call screen, select Camera On.
Stop Sending Video During a Call
During a video call, you can start and stop sending video at any time.
NOTE: You can’t start or stop far-end video. If your phone receives far end video,
the far end video always displays.
■
Do one of the following:
● Close the privacy shutter.
Far side participants see a blank screen in place of your video.
● Select Camera Off.
Far side participants see a video muted icon instead of your video
stream.
Video Call Settings
Update video settings to change the way video calls display on your video-enabled
phone.
If you update settings during a call, the phone does not apply them until the next
call.
NOTE: Some of the features described in this section require access to the
Basic settings menu. If your phone requires a password to access the Basic
settings menu, contact your system administrator for assistance.
Set the Call Rate for Video Calls
You can set the maximum call rate to use for a video call. The new call rate applies
to your next video call.
You can choose a call rate between 128 kbps and 4096 kbps. The default setting is
2048 kbps.
NOTE: Your system administrator can set a maximum call rate for video calls,
and you can’t select a call rate above this limit.
1. Go to Settings > Basic > Call Rate.
2. On the Call Rate screen, select the maximum call rate you want to use for
video calls.
Start Video During a Call
41