■
On the side of the camera lens, rotate the Privacy Shutter Adjuster from the
left to the right.
Camera Status Indicators and Messages
Your camera uses LED indicators as well as messages on the phone’s screen to
communicate its status.
Use the following tables to understand the LED indicators and onscreen
messages.
Table 6-1 Camera LED Indicators
LED State Phone State
No LED One of the following:
● Phone has no power
● Camera shutter is closed
Flashes amber and green Camera firmware is updating
Green Video call is connected
Amber The camera is on and the shutter is open, but no
video is being sent.
Table 6-2 Camera Messages
Message Action
Camera attached. Firmware sync in progress, do
not remove camera.
(CCX 600 only)
Your camera is upgrading. Don’t remove your
camera during this process. The upgrade is
complete when you receive a message stating
that either “firmware sync complete” or “upgrade
failed”.
Camera firmware sync complete. Camera ready. Indicates that your camera is ready to use.
Camera firmware sync complete. Contact
administrator to enable video.
Indicates that your camera is ready to use.
However, your phone is not enabled to
send and receive video. Contact your system
administrator to enable video calls.
Camera firmware sync complete. Camera
rebooting.
Indicates that the camera firmware sync is
finished and your camera is in the process of
rebooting.
Camera firmware sync complete. Video available
when next idle.
Indicates that your camera is ready to use for
your next video call.
Camera attached, camera ready.
(CCX 600 only)
Indicates that your camera is ready to use.
Camera attached. Contact administrator to
enable video.
(CCX 600 only)
Indicates that your camera is ready to use.
However, your phone isn’t enabled to send
and receive video. Contact your system
administrator to enable video calls.
Camera attached. Video available when next idle.
(CCX 600 only)
Indicates that your camera is ready to use for
your next video call.
46 Chapter 6 Video Calls
To Next Page
Loading...
