3. Select Save.
Display All Video Calls in Full Screen Mode
By default, the far-side video always displays in the Active Call screen. You can
enable your phone to display all incoming videos on the full screen.
1. Go to Settings > Basic > Video.
2. Select Video Call Settings and select Auto Video Full Screen > Enable.
When enabled, this setting automatically enables your phone to display far-
side video in full screen. When disabled, far-side video is displayed in the
smaller Active Call screen.
3. Select Save.
Mixed Audio and Video Calls
Your system displays different options based on the equipment you and your
contacts use during a call.
● When you are in a call with contacts who have video-enabled phones, the
participants’ video displays onscreen.
● For video calls with audio-only contacts, your video stream displays an
Audio icon with the number of contacts on audio.
● Video always displays in a video call when a contact can send video.
No Video from the Far Side
If the far side stops sending video, a No Video icon is displayed on your phone.
Using a USB Camera with Your Phone
To transmit video during calls, attach a USB camera to your CCX 600 phone.
NOTE: If your phone doesn’t detect the USB camera, you may need to ask your
administrator to enable the USB port.
Reference the setup sheet for instructions on attaching the camera to your phone.
After the camera is attached to your phone, a message indicating that your
camera firmware is updating and syncing with your phone displays. Don’t remove
the camera during this process.
For assistance verifying that your phone is video enabled and has the latest
software installed, check with your administrator.
Use the Privacy Shutter on the Camera to Stop Sending Video
You can use the privacy shutter on your USB camera to stop transmitting video
during a call.
Display All Video Calls in Full Screen Mode
45
To Next Page
Loading...
