Polyend Play+ - Page 116

116
Polyend Play+ Manual Rev 2
NOTES
Sequencing Patterns
6
▌ EDITING INDIVIDUAL STEP PARAMETERS
1. Ensure sequencing mode is selected. If pattern mode or perform mode
is selected, Press [Patterns] or [Perform] respectively to toggle back to
Sequencer mode. This is the grid view which allows an individual
pattern to be sequenced.
2. For the active step to edit, Hold [Pad] + Turn (Knob) for the parameter
to edit. Multiple or blocks of steps can also be selected and held to
adjust collectively.
3. If the sequencer is stopped, the step will be auditioned as the edit is
performed.
4. Release the pad when complete. Take care to hold and not to briey tap
the pad as this will delete the step.
5. Double Tap [Screen] left or right screen button for the selected
parameter in view to reset it to its default values.
▌ EDITING ALL STEPS ON A TRACK
1. Ensure sequencing mode is selected. If pattern mode or perform mode
is selected, Press [Patterns] or [Perform] respectively to toggle back to
Sequencer mode. This is the grid view which allows an individual
pattern to be sequenced.
2. Select the track to edit. Press [Select] green function pad. Selected
pads are lit bright green (or purple in MIDI Mode). Multiple track rows
can be selected.
3. Turn (Knob) for the parameter to edit. The parameter will be adjusted
for all steps across all of the selected tracks. The parameter value is
adjusted relative to the original value.
4. A ‘~’ symbol in the parameter value indicates that multiple parameters
are selected with different values. If values are all identical this value is
displayed. A +/- value will be displayed as the offset from the original
setting on the parameter display.
5. Double Tap [Screen] left or right screen button for the selected
parameter in view to reset it to its default values.
6. To remove all selections, Tap [Shift]. Any selection, not actual note step,
is removed. Use [Shift] + [Fill] to Delete a note step if required.