Preproofer 770 - Page 113

Setup Electronic Box – HW Revision 2 – Nov 2011
Calibrate the CUT Motor Parameter
12
Preproofer x700 / x900 – HW Installation Manual 12-7
PP x700/x900 v1.7
Step 2
On the printer panel, change to the menu
“Maintenance” and press ENTER.
Step 3
Change to the menu “Cutter Replacement” and
press ENTER.
Step 4
The menu entry “Execute” comes up. Press
ENTER.
Step 5
The cutter moves to the service position.