124
Chapter 3 Soft vs. Hard Reset
Soft vs. Hard Reset
Soft Reset
A soft(ware) reset clears printer memory then loads the power-up
configuration set by the user. (If no power-up configuration has been set by
the user, the factory default configuration is loaded.) It is called a soft reset
because no hardware is tested. All diagnostic and initialization tests are
bypassed and memory is simply refreshed with the power-up printer
configuration.
The printer must be off-line to do a soft reset:
1. Press the ON LINE key to put the printer in the off-line state.
2. Press the
; (PREV) + < (NEXT) keys simultaneously.
The LCD will display “Standby / Soft Reset” while the printer loads the power-
up configuration.
Hard Reset (“Cycle Power”)
A hard(ware) reset is a power shutdown and restart that runs all initialization
and diagnostic routines. This is also called “cycling power.”
1. Set the printer power switch to O (off).
2. Wait 15 seconds.
3. Set the printer power switch to 1 (on).
NOTE: A hard printer reset causes the +48V power supply (fans, motors,
etc.) to shut down in 1 to 5 seconds, depending on the amount of
memory installed on the controller board.
To Next Page
Loading...
