Cover Assembly, Top, Pedestal Models
179
Cover Assembly, Top, Pedestal Models
Removal
1. Prepare the printer for maintenance (page 132).
2. Loosen—do not remove—the two #2 Phillips hold-down screws on the
rear of the printer. (See page 228, item 5.)
3. Open the printer cover.
4. Loosen the four captive #1 Phillips screws until the control panel is
released from the printer top cover assembly. (See page 228, items 1 and
2.) Set the control panel assembly on the shuttle cover assembly.
5. Loosen the two captive #2 Phillips screws in the lower front corners of the
top cover. (See page 228, item 3.)
6. Lift the top cover assembly off the printer base.
Installation
1. Reverse steps 2 through 6 of the removal procedure.
2. Return the printer to normal operation (page 133).
To Next Page
Loading...
