Adjustments and Tests
133
Returning The Printer To Normal Operation
When you are finished servicing the printer, test its operation and return it to
service by doing the following steps:
1. Install the ribbon.
2. Load paper.
3. Connect the data (signal) cable to the printer interface.
4. Plug the AC power cord into the printer and the power source.
5. Close the cabinet doors.
6. Set the printer power switch to | (on).
7. Test printer operation by selecting and running one of the operator print
tests. (See page 114.)
8. Select the emulation. (Refer to the User’s Manual.)
9. Set the top-of-form. (Refer to the User’s Manual.)
10. Close the printer cover.
To Next Page
Loading...
