Ribbon Drive Motor
209
Ribbon Drive Motor
Removal
1. Prepare the printer for maintenance (page 132).
2. Remove the ribbon hub (page 211).
3. Remove two screws and washers securing the ribbon drive motor to the
base casting. (See page 244, items 13 and 14.)
4. Lift and rotate the ribbon drive motor until the motor cable is aligned with
the slot on the base casting.
5. Disconnect the ribbon drive motor cable connector.
6. Remove the ribbon drive motor.
Installation
1. Reverse steps 2 through 6 of the removal procedure above.
NOTE: Secure the ribbon drive motor at the front right and rear left corners.
(See page 244, item 17.)
2. Return the printer to normal operation (page 133).
To Next Page
Loading...
