List of Illustrations
365
Illustrated Parts Breakdown
The Illustrated Parts Breakdown (IPB) consists of exploded drawings of the
power stacker assembly and subassemblies. Parts are listed next to each
drawing.
IMPORTANT
The Phase III (newest) power stacker is illustrated in this section. If the
stacker you are working on does NOT look like the one illustrated here,
order the part designated Phase II if the part has both a Phase II and
Phase III listing. If a part is not listed as both Phase II and Phase III, you
can use that part on any stacker.
Only replaceable parts are assigned part numbers. If a part or assembly is
damaged but does not have a part number, replace the entire power stacker
assembly.
The IPB starts on the next page.
List of Illustrations
Figure 94. Stacker Assembly .......................................................... page 366
Figure 95. Elevator Detail: Motors, Rollers, and Paddles ............... page 368
Figure 96. Stacker Detail: Rollers ................................................... page 370
Figure 97. Stacker Detail: Motor Bracket ........................................ page 372
Figure 98. Stacker Detail: Elevator Bracket .................................... page 374
Figure 99. Stacker Detail: Paper Motion Detector........................... page 376
Parts Not Illustrated Here:
• Extended Door Kit:156300-901
• Reed Limit Switch Assembly (Phase III only): 204234-001
• Power Stacker Limit Switch Field Kit (Phase II only): 170285-001
• Rear Control Panel Assembly (Phase III): 174780-001 (Figure 82, page
355)
• Rear Control Panel Assembly (Phase II): 158732-901
• Stacker Hardware Kit: 173830-001
• Power Stacker Pivot Arm Field Kit (Phase I only): 170306-001
• Rail Cable, Power Stacker: 173823-001 (See page 313)
• Power Cable, Power Stacker: 174414-001 (See page 312)
• Logic Cable, Power Stacker: 158444-001 (See page 311)
• Frame Cable, Power Stacker: 173824-001 (See page 310)
• Elevator I/O Cable, Power Stacker: 174759-001 (See page 314)
To Next Page
Loading...
