388
Appendix F Form Design Checklist
Thickness Buildup = ________ in. / cm
NOTE: A cut-to-tie ratio that causes a thickness buildup greater than 0.025
in. / 0.0635 cm, or that creates an evenness variation greater than
0.003 in. / 0.00762 cm, will result in an unreliable and unpredictable
form.
Perforation Intersections
________ Horizontal-vertical perforations are tie points. Cut points at
such intersections are unacceptable.
Chaff Content
________ Tractor holes are clear of chaff.
________ There is no loose chaff in the box the paper is packed in.
To Next Page
Loading...
