powersavingidletime= After an HDD has been idle for the set period of time, parks the read/write
heads. Set the time interval in number of minutes. Valid values are
0(never), 15, 30, 60(= 1 hour)..1440(=24 hours).
powersavingstandbytime= After an HDD has been idle for the set period of time, lowers disk rotation
speed. Set the time interval in number of minutes. Valid values are
0(never), 15, 30, 60(= 1 hour)..1440(=24 hours).
powersavingstoppedtime= After an HDD has been idle for the set period of time, Spins down the
disk (stops rotation). Set the time interval in number of minutes. Valid
values are 0(never), 15, 30, 60(= 1 hour)..1440(=24 hours).
VAAIsupport= To enable or disable VAAI support.
enable
disable
pseudodevicetype= pseudo device type
das DAS
ctrl Storage controller device
-t <condition type> Used to specify the type of condition to clear. It is valid only when the
command action is “clear”.
watermark Watermark, the only supported condition for now. It is used together with
-a clear to clear the orphan migration watermark in the controller NVRAM.
This will work only when migration storage is set to NVRAM prior to
starting migration.
-l Display local controller’s id that CLI runs through its serial port.
-v Verbose mode. Used with -a list.
205
Promise Technology
Managing with CLI
To Next Page
Loading...
Need help?
General
