If a disabled device activated while in an disabled condition, when the device is selected
for normalisation the LCD will display the following warning message
• Exiting Option : Press ‘ESC’ then physically inspect the device and check for the cause of the
activation. Ie) Broken glass in the Break glass point, dust contamination within a smoke
sensor etc. This will return the display to the ‘Disablement menu’ and the device will
remain disabled.
• Selecting Option : Once the cause has been rectified, return to this menu and press the ‘ENTER’ key to
normalise the device. Since the system is aware that this device has been activated it will
perform a loop reset.
To Next Page
Loading...
