PRÜFTECHNIK VIBXPERT II - Creating a Multi-Measurement Task for a Route; Machine Template; Breaking Down a Multi-Measurement Task

5-21
VIBXPERT II 05.2012
Measurement tasks
Left:
Breaking down
a multi-measurement task
(Route / Machine template)
Right:
Individual measurement tasks
Creating a Multitask
(in the OMNITREND route editor)
Creating a multi-measurement task for a route / machine template
Multi-measurement tasks for this operating mode are created in the
OMNITREND editor for routes or machine templates. To do this, acti-
vate the 'Multitask' option (see below). OMNITREND then automati-
cally combines the relevant measurement tasks into a single multi-
measurement task.

Note
Breaking down a multi-measurement task
To measure the measurement tasks of a multi-measurement task indi-
vidually in the route/machine template, proceed as follows:
• Opentheselectionlistofthemeasurementtasks(seeP.3-8).
• Highlightthemulti-measurementtask.
• PresstheMENUkeyandclickon'BreakdownMultitask'(seebe-
low).
Thisprocessisnotreversible(seeP.3-10)!