Learn about basic navigation through EasyRoll
Learn about ZPA settings and how to change them
How to change motor direction, speed, accel/decel, etc.
Learn about motor status and error indicators
How to change Jam Timers and Auto-Clear Timers
How to change how the module logic uses the block/clear output from your
sensors
How to change your Aux I/O Pins to match the signals you are using
Some advanced things you can do with EasyRoll
Learn how to discover modules on your network and change IP addresses
How to set up Look Ahead Slow Down feature
How to disable Flex Zone Recognition and why you may want to
How to set up an Extension or slave module
How to connect two separate networks together to operate in ZPA
How to backup and restore module settings
How to upgrade module firmware
Last modified: Aug 04, 2020
PULSEROLLER ConveyLinx-Ai2 User's Guide - 1.7
Page 9 of 154
To Next Page
Loading...