7.1. Main Screen
Indicator Description
Network IP – This is where you enter the Subnet of the particular ConveyLinx network
you wish to connect
Node No. – This is where you enter a range of Nodes in which to connect. Entering
values here will cause the “Refresh” button to enable. Clicking this button will cause the
rest of the items (3, 4, and 5) to be populated
Upstream Zone / Downstream Zone – These selections allow you to change the ZPA
mode of the particular zone as well as several check boxes to change the default
PULSEROLLER ConveyLinx-Ai2 User's Guide - 1.7
Page 69 of 154
To Next Page
Loading...