7.1.3.4. Accumulate Control from Main Screen
Clicking the Accumulate switch icon will place the zone in accumulation mode and the next carton that
arrives at that zone will stop and remain until you click the switch again to turn off the accumulation mode
Clicking the icon will initiate the
Accumulate function and the icon will
highlight and change state
Clicking the icon again will turn off the
Accumulate function
Last modified: Aug 18, 2020
When you set Accumulate from EasyRoll, this is saved to the module’s flash memory so
that when you cycle power on the module, it will power up in the accumulated state.
*
PULSEROLLER ConveyLinx-Ai2 User's Guide - 1.7
Page 82 of 154
To Next Page
Loading...