7.2.7. Sensors Tab
The Sensors tab displays the status of how the two sensor signals were configured during the Auto
Configuration Procedure. If for some reason one or more of the sensors was not configured properly during
the Auto Configuration Procedure; for example they were not aligned with their reflector or there was an
obstruction blocking the sensor at the time the procedure was performed, the Sensors Tab will allow you to
change the sensor’s configuration without requiring you to re-perform the Auto Configuration Procedure
for the entire subnet. For example, if all the sensors on the system are light energized normally open then
the corresponding zone’s sensor graphic on this tab will show Off Blocked.
Click the appropriate icon to change
either or both sensor’s blocked signal
state. Note that you can make the same
change for a group of modules by clicking
the Set All Sensors this Way button
Last modified: Aug 18, 2020
PULSEROLLER ConveyLinx-Ai2 User's Guide - 1.7
Page 131 of 154
To Next Page
Loading...
Need help?
General