2. Glossary of Terms
Term Definition
Carton
A separate (usually wrapped or boxed) object to be transported by the conveyor. The
terms tray, tote, load, or product may also be used interchangeably in this document.
ConveyLinx
Conveyor controls architecture based upon modular distributed devices connected via
Ethernet network.
ConveyLinx-Ai /
ConveyLinx-Ai2
Conveyor control module that is part of the ConveyLinx family. Each module can
accommodate up to 2 MDR conveyor zones. The modules allow connection for
Senergy-Ai platform motor rollers and gear drives. The term Module will be used within
this document and will refer to the ConveyLinx-Ai2 device
DHCP
Dynamic Host Configuration Protocol A protocol for assigning IP addresses to devices
on a network from a pool of available IP’s. A dynamic IP address changes each time the
device connects to the network
ERSC
Ethernet Roller Speed Control module – Conveyor control module that is part of the
ConveyLinx family. Each ERSC can accommodate up to 2 MDR conveyor zones. In this
document the term module will be synonymous with ERSC
ERSC-SE4
Designed to “break-out” the RJ11 connection for easy installation. The module has an
amplifier to the output giving it up to 100mA output capabilities. Configurable diodes for
the inputs to minimize leakage current to and from the ERSC. Module also allows for
external power source connection for auxiliary devices.
Hall Effect Sensor
Special sensor embedded within the brushless DC motor of an MDR used to provide
motor rotor position feedback to the motor controller
IP54
The IP Code (International Protection Marking) specifies the device’s degree of
resistance to intrusions, dust and water. IP54 certified device must be fully protected
from splashed water, dust particles and completely protected from contact
JST
This is the name of a particular connector manufacturer that produces a specific plug/
socket arrangement for MDR connection to control cards. This name is accepted within
the conveyor and MDR industry as a simple description of the particular socket style
used on ERSC hardware.
LED
Light Emitting Diode – In the context of this document, LED’s are used on the
ConveyLinx-Ai2 to provide visual indication of module status
Light / Dark
Energized
Term used to describe how the signaling output circuit of a photo-sensor is configured
when it detects its reflected light. A photo-sensor that is light energized will activate its
output circuit when it detects its reflected light. A dark energized photo-sensor will
activate its output circuit when it does not detect its reflected light
M8
This is the type of a connector, which has four connector pins and is used on the
ConveyLinx Ai2 modules for both sensor connectors and MDR connectors
MDR
Motorized Drive Roller or Motor Driven Roller – Brushless DC motor and gearbox
assembly integrated into a single conveyor roller
PULSEROLLER ConveyLinx-Ai2 User's Guide - 1.7
Page 5 of 154
To Next Page
Loading...