7.1.3.5.2. Disable Sensor Jam Auto Clear
Sensor Jam Auto Clear Procedure describes how the logic will make 3 attempts to clear a Sensor Jam if
one occurs. There may be instances at specific zones or range of zones where you do not want this
functionality to happen. There is a check box that allows you to disable this functionality
Clicking the Disable Sensor Jam Auto
Clear check box will disable the 3 attempts
to clear the Sensor Jam and will cause the
zone to remain in the jam state until the
sensor is cleared manually
Last modified: Aug 18, 2020
You can also attempt to clear a Sensor Jam using the Clear button for the Zone
*
PULSEROLLER ConveyLinx-Ai2 User's Guide - 1.7
Page 85 of 154
To Next Page
Loading...