Pulseroller ConveyLinx-Ai2 User Manual

7.2.1.5. Sensor Debounce
Sensor Debounce setting is the time the logic holds the state of its Sensor inputs after a change of state.
Keep in mind this is not a delay prior to detecting a carton when it first blocks the sensor. The module will
detect the leading edge of a carton and hold this state for the Sensor Debounce time period. Similarly,
when the trailing edge of the carton clears the sensor, the logic holds this state for the Sensor Debounce
time period.
Enter the desired value in seconds and
click the Set button. The default is 0.1
seconds and the valid range is 0 to 2
seconds. Please note this setting applies
to both the Left and Right Sensor ports.
The Set All button will apply these same
settings for the range of modules
indicated at the top of the dialog. In this
example we are changing the Sensor
Debounce time to 0.30 seconds and
updating this setting using the Set All
button for Nodes 3 thru 4.
PULSEROLLER ConveyLinx-Ai2 User's Guide - 1.7
Page 111 of 154

Pulseroller ConveyLinx-Ai2 Specifications

General

Brand	Pulseroller
Model	ConveyLinx-Ai2
Category	Control Unit
Language	English