6. Default Settings and Operation
After Auto-Configuration, the modules on your newly configured network are in ZPA mode and set to
Singluation Release.
If all module and/or Network Status LED’s are blinking green; then to fully verify configuration is to place a
single carton onto the most upstream zone and see that it conveys to the discharge zone. If it does, then the
Auto-Configuration Procedure is successful.
Learn About:
Singulation Release Mode
Flex Zone Recognition
Jam Conditions
Automatic Module Replacement
How to Reset to Factory Defaults
Last modified: Aug 05, 2020
PULSEROLLER ConveyLinx-Ai2 User's Guide - 1.7
Page 55 of 154
To Next Page
Loading...