QuickLabel Systems QLS-4100 User Manual

4-60 Keypad controls and menus
Cutter
If using an optional cutter or cutter/stacker accessory, you can enable it using
the Cutter menu option.
To enable or disable the cutter:
1 If the printer is in a Ready state, press the PRINT/PAUSE key to pause
the printer.
2 Press the NEXT or PREVIOUS key until the Options menu is displayed.
Then press the SELECT key.
3 Press the NEXT or PREVIOUS key until the Cutter menu is displayed.
4 Press the + or – key until the desired setting is displayed. Available
options are Enabled or Disabled.
5 Press the SELECT key to confirm your choice.
Cutter
Enabled
Pause: Options
Press SELECT

QuickLabel Systems QLS-4100 Specifications

General

Brand	QuickLabel Systems
Model	QLS-4100
Category	Label Maker
Language	English