QLS-4100 Xe 5-5
Error Messages
The following pages show a number of possible error messages that may be
encountered during operation. Instructions are provided on how to clear the
condition that caused the error message to be displayed.
• The label or tag media has been consumed. Reload a new roll of media.
• The printer has not been properly calibrated. Recalibrate for the proper
media.
• The sensor has been repositioned off of the gap or notch. Ensure that the
sensor position is correct and recalibrate if necessary.
• The printer requires media recalibration.
• The label or tag media has been consumed. Reload a new roll of media.
• The media is not making positive contact with the Media Travel Roller or
the media travel roller is not turning freely. Ensure that the roller spins
freely and that the media is making contact with the roller causing it to
turn at a regular rate.
• The printer is out of ribbon on one or more print stations. Reload a new
roll of ribbon on the indicated print station(s).
• The ribbon unwind is not turning at a steady rate. Ensure that the
ribbon has been loaded correctly and that the ribbon unwind tension has
not been set too high.
ERROR: Media out or
Motor Stall
Ribbon Out!!!
Ribbon 1
ERROR: Media out or
sensor is off media
To Next Page
Loading...
Need help?
General
