QLS-4100 Xe 4-21
Label Reprint
When using the QuickLabel Printer Driver for Windows to print to the QLS-
4100 Xe, data is transmitted from the PC software application to the printer
as a bitmapped image. You can use the Reprint option to quickly print any
quantity of the last label printed.
To reprint labels:
1 If the printer is in a Ready state, proceed to the next step.
If the printer is in a Pause state, press the NEXT or PREVIOUS key until
the Operation menu is displayed. Then press the SELECT key.
2 Press the NEXT or PREVIOUS key until the Label Reprint menu is
displayed.
3 Press the + or – key to specify the number of the last labels you wish to
reprint. You can reprint up to 999 copies.
4 Press the SELECT key. The quantity you specified will be printed.
Form Stop Adjust
When labels are printed, they are advanced from the front of the printer for
removal. In Print & Peel single label mode, you can increase/decrease the
distance labels are advanced after printing.
Note: This option is available only in Print & Peel single label mode. For
more information about Print & Peel, refer to Chapter 8: Print & Peel.
Label Reprint
Copies = 1
Pause: Operation
Press SELECT
To Next Page
Loading...
Need help?
General
