QLS-4100 Xe 4-39
To use the Drop/Lift Adjust function:
1 If the printer is in a Ready state, press the PRINT/PAUSE key to pause
the printer.
2 Press the NEXT or PREVIOUS key until the Ribbon menu is displayed.
Then press the SELECT key.
3 Press the NEXT or PREVIOUS key until the Drop/Lift Adjust menu for
the desired printhead is displayed.
4 Press the + or – key until the desired drop setting is displayed. Drop
settings range from 0 to 40 mm. The default value is 6. Increasing this
value will cause the printhead to drop sooner, and decreasing the value
will cause the printhead to drop later.
5 Press the SELECT key to confirm your choice.
Any changes will take effect only after a new label is sent.
Drop/Lift Adjust
Head 3 = 6
Pause: Ribbon
Press SELECT
To Next Page
Loading...
