Page 41 of 254
3.1.5 Mounting the Sonic 2024/2022 Projector
The projector is secured to the frame with two, 35mm
standoffs. The stand-offs allow room for the Projector to
Receive Module cable to be run. A 6mm drive hex screw secures the
projector through the stand-off. The Projector’s connector faces
towards the protection fin. Connect the 0.439m interconnect cable’s
female end to the Projector’s male bulkhead connector. When the
connectors are mated, there should be no visible gap between them. A
very light spray of silicone lubricant will aid seating the connector.
Figure 28: Projector Stand-off
Figure 29: Mounting the projector
Figure 27: Sonic 2024 Projector
To Next Page
Loading...
