32
15.1.1. Port
Parameter allowing you to set port for communication between the weighing
device and the computer. Available ports:
RS232 (1)
RS 232 (2) *
RS 232 (3) *
RS 232 ports (M12 8P connectors).
Ethernet Ethernet port (RJ45 connector).
*) – optional design.
Procedure:
• Enter <Peripherals / Computer / Port> submenu and select respective
port, <Port settings> submenu differs depending on the selected port:
Port Settings
RS232 (1)
RS 232 (2) *
RS 232 (3) *
Baud rate: 2400 - 115200 bit/s.
Parity: None, Odd, Even.
Ethernet
IP Address: IP address of the scale.
Port: number of port for transmission protocol.
Timeout [ms]: time delay - time interval for disconnection, counted from
the moment of the most recent command sent from the peripheral
device to which the weighing device is connected.
*) – optional design.
15.1.2. Address
Parameter allowing you to set address of scale connected with the computer.
Procedure:
• Enter <Peripherals / Computer / Address> submenu, <Address> edit
box is displayed.
• Enter the address and press
key to confirm changes.
15.1.3. Weighing Printout Template
Template of an individual printout designed using scale and sent to a computer.
Procedure:
• Enter <Peripherals / Computer / Weighing printout template>
submenu, <Weighing printout template> edit box is displayed.
• Modify the template and press
key to confirm changes.
To Next Page
Loading...
