RADWAG PUE HX7

65
On-screen button
(working mode parameters) that is to be
found in each working mode home screen, provides direct
access to settings of the given working mode.
26.1. Readout
Readout submenu comprises functions allowing you to adjust your weighing
device to ambient conditions of a given workstation.
Filter
Enter this parameter to adjust your weighing device to ambient conditions.
The higher filter level, the longer the indication takes to stabilise. Options:
Very fast, Fast, Average, Slow, Very slow.
Value Release
Enter this parameter to adjust rate of stabilisation of the measurement result.
Depending on the selected option, weighing time is either shorter or longer.
Options: Fast, Fast plus reliable, Reliable.
Last digit
Enter this parameter to enable/disable display of the last digit (placed on the
right of the decimal point) of the weighing result. Options: Always: all digits
are displayed. Never: last digit disabled. When stable: last digit displayed
only when the result is stable.
Autozero
Enter this parameter to enable automatic control and correction of zero
indication. There are, however, some cases when this function can be a
disturbing factor for the measuring process. e.g. very slow placing of a load on
the weighing pan (load adding, e.g. pouring, filling). In such case, it is
recommended to disable the function. Options:
- function disabled, -
function enabled.
Ambient
conditions
Parameter relating to ambient and environmental conditions of the
workstation. Enter this parameter and set 'unstable' value if the ambient
conditions are unfavourable (air drafts, vibrations). Options: Stable, Unstable.
26.2. Save Mode
Parameter allowing you to set mode of sending data from the weighing device
to a peripheral device.
Procedure:
• Enter <Working modes> menu and select respective working mode.
• Enter <Save mode> submenu and select respective save mode.
Save mode options list:
Manual each stable
Manual printout of each stable weighing result above <Auto
threshold>.
Manual first stable
Manual printout of the first stable weighing result above
<Auto threshold>.
Automatic first stable
Automatic printout of the first stable weighing result above
<Auto threshold>.