72
Total mass of all the pieces loaded onto the weighing pan
must not be lower than value declared in „Minimum reference
sample mass” parameter. Unless this condition is met, the
weighing device displays a message: <Sample mass too low>.
28.3. Setting Reference Sample Mass by Entering Mass of a Single Part
• Press button (Set part mass), <Reference sample mass> edit box
featuring an on-screen keyboard is displayed.
• Enter respective value and press
key to confirm, <Parts
counting> working mode is run with automatically set mass of a single
part.
If the value of entered single part mass is greater than max
capacity value, then the following message is displayed:
<Value too high>.
If the value of entered single part mass is lower than 0.1 of the
reading unit, then the following message is displayed: <Value
too low>.
28.4. Setting Reference Sample Mass by Determining Mass of a Single
Part
If the parts are to be weighed in a container, first put the container on
a weighing pan and tare it.
• Press
button (Determine part mass), <Reference sample quantity>
edit box featuring an on-screen keyboard is displayed.
• Enter respective value and press
key to confirm, the following
message is displayed: <Number of parts to be loaded: xx> (where xx –
previously entered value).
• Load the weighing pan with declared amount of parts. When the indication
is stable (
pictogram is displayed), press key to confirm the
mass.
• Single part mass is calculated automatically, <Parts counting> working
mode is run and the weighing device displays quantity of single parts
(pcs).
Total weight value of all parts loaded onto the weighing pan
cannot be greater than the max capacity value.
To Next Page
Loading...
