67
26.5. Autotare
Autotare function allows you to quickly determine net weight for loads
with different tare values, which loads are measured one after another.
When <Autotare> function is on, the operation cycle takes the following steps:
• Make sure that the weighing pan is empty and press zeroing key.
• Load the weighing pan with product packaging (packaging weight value
must be greater than the set value of <Auto threshold> parameter).
• Upon indication stabilization, packaging mass is automatically tared
(
pictogram is displayed in the upper part of the display).
• Put/pour/dispense product that is to be packed into the packaging.
• Unload the weighing pan (remove both product and packaging).
• When the weighing device detects weight value lower than
<Auto threshold> value, the entered tare value gets automatically
deleted (
pictogram is no longer displayed).
• When you load the weighing pan with a new product packaging,
analogous set of operations proceeds.
26.6. Labelling Mode
Labelling system is designed to print labels for product marking. The program
generates standard labels, for single products, and cumulative labels, for bulk
boxes.
Custom functions of <Labelling mode> submenu:
Labels quantity
Parameter for declaring number of labels to be printed on the
scale-connected printer.
C labels quantity
Parameter for declaring number of C labels to be printed on
the scale-connected printer.
Automatic C label triggering For detailed description read section 26.6.1.
26.6.1. Automatic C Label Triggering
Automatic C Label Triggering function allows to trigger printout of C label, to do
it you must define <Mode> and <Threshold> parameters.
Procedure:
• Enter <Working modes> submenu and select respective working mode.
• Go to <Labelling mode / Automatic C label triggering / Mode>
parameter and set respective option, where:
To Next Page
Loading...
