80
• Upon exceeding the value of dosing threshold, dosing outputs are
activated and PS=OK process status is displayed.
• In case of active time delay, countdown of declared time starts.
• After countdown completion, PS=Completed status is displayed (process
completed). Blinking pictogram
is turned off.
30.4. Manual Dosing Procedure
• Save general parameters of 'Dosing' mode to scale memory,
the parameters are to be found upon pressing a key to which
pictogram is assigned.
• Press key to which
pictogram (process start) is assigned, now scale
keypad is locked except for
- stop, - pause, - breakdown keys.
When:
1. Dosing outputs are declared incorrectly (e.g. lack of active MIN or MAX
outputs) the following message is displayed: <Dosing outputs
determined incorrectly>, next the process is cancelled.
2. The weighing result is unstable then the following message is displayed:
<Unstable weighing result>. The process status changes to PS=Pause
and remains so until stable weighing result is obtained.
• Upon process start, bar graph of dosed material mass is displayed with
the following data:
Top bar pictograms:
process in progress (blinking pictogram).
To Next Page
Loading...
