RADWAG PUE HX7

66
Automatic last stable
Automatic printout of the last stable weighing result
detected upon the weight value gets below <Auto
threshold>.
Semi-automatic each stable
Manual printout of each weighing result, where the weight
value is above -LO- threshold; this option requires awaiting
for the stable weighing result.
Semi-automatic first stable
Manual printout of the first weighing result, where the weight
value is above -LO- threshold; this option requires awaiting
for the stable weighing result.
26.3. Auto Threshold
<Auto threshold> parameter allows you to configure the function of automatic
operation. The next measurement is saved when mass indication gets below
the set net value of <Auto threshold> parameter.
Procedure:
• Enter <Working modes> submenu and select respective working mode.
• Enter <Auto threshold> submenu and provide respective value, next
press
key to confirm changes.
26.4. Result Control
When your weighing device operates with 'result control' mode on, the printout
is carried out only when mass of load placed on the weighing pan is comprised
within MIN, MAX thresholds. If the 'result control' mode is on, respective
pictograms are displayed on the right of the weighing result window,
, ,
.
Procedure:
• Enter <Working modes> menu and select respective working mode.
• Enter <Result control> submenu and set respective option.
Where:
Each weighing is recorded.
Weighings between MIN, MAX thresholds are recorded.
For detailed description on how to set MIN, MAX thresholds
refer to section 13.6.
For MIN=0 and MAX=0
, , pictograms are inactive.