40
Enter <Communication> submenu and set baud rate, mind
that the set value must be accordant with the additional
display (115200b/s).
15.4.2. Bottom Text Area Template
Additional display features text area for extra information such as date, tare
value etc. Displayed data content is set using the weighing device.
Procedure:
• Enter <Peripherals / Additional display / Bottom text area template>
submenu, <Bottom text area template> edit box is displayed.
• Modify the template and press
key to confirm changes.
The template can comprise 30 characters maximum.
16. DIODE BAR GRAPH
Diode bar graph takes top part of the operation panel, it consists of 9 red and
green diode fields. It is a graphic visualisation informing you how much of the
weighing device capacity is used. It allows you to observe whether the load
stays within the specified Max capacity or is out of it. It also shows position
of Min and Max thresholds. In order to set diode bar graph enter <
/
Diode bar graph> submenu.
16.1. Activation
Parameter allowing you to enable / disable diode bar graph.
Procedure:
• Enter <Diode bar graph / Activation> submenu and activate diode bar
graph
( - diode bar graph enabled, - diode bar graph disabled).
16.2. Diode Bar Graph Type
Parameter allowing you to set diode bar graph type.
Procedure:
• Enter <Diode bar graph / Diode bar graph type> submenu and set the
respective option.
To Next Page
Loading...
