Contents
R&S
®
NRP2
4User Manual 1173.9157.02 ─ 03
4.5 Displaying traces......................................................................................................112
4.6 Management of settings...........................................................................................139
4.7 System settings.........................................................................................................143
4.8 Messages and alarms...............................................................................................163
5 Remote Control Fundamentals.........................................................167
5.1 Differences between Remote Control and Manual Control...................................167
5.2 Connecting a Controller to the Base Unit...............................................................168
5.3 Switchover to Remote Control (REMOTE)..............................................................170
5.4 Return to Manual Operation (LOCAL).....................................................................170
5.5 Automatic Settings when Switching between Local and Remote........................170
5.6 Communication on Data Lines................................................................................171
5.7 Structure and Syntax of device-dependent Messages..........................................173
5.8 Device Model and Command Processing...............................................................180
5.9 Automatic Settings for Manual Selection of a Measurement Mode.....................182
5.10 Correspondence between Remote Control and Manual Control..........................184
6 Remote Control - Commands...........................................................191
6.1 Notation......................................................................................................................191
6.2 Common Commands to IEEE 488.2........................................................................192
6.3 Overview of SCPI Command Systems....................................................................203
6.4 High-Level Measurement Commands (CONFigure, MEASure, READ and FETCh)
....................................................................................................................................206
6.5 CALCulate (Configuration of Calculate Blocks).....................................................221
6.6 CALibration ...............................................................................................................234
6.7 DISPlay.......................................................................................................................236
6.8 FORMat......................................................................................................................246
6.9 MEMory......................................................................................................................247
6.10 OUTPut.......................................................................................................................253
6.11 SENSe (Sensor Commands)....................................................................................259
6.12 SERVice.....................................................................................................................290
6.13 STATus.......................................................................................................................292
6.14 SYSTem......................................................................................................................314
6.15 TRIGger......................................................................................................................324
6.16 UNIT............................................................................................................................331
To Next Page
Loading...
