R&S NRP2 - Trigger

Remote Control - Commands
R&S
®
NRP2
324User Manual 1173.9157.02 ─ 03
SYSTem:TIME <hour>,<minute>,<second>
Sets the time. Since the R&S NRP2 has no battery-backed clock, the time has to be reset
if the clock was not set after the last power-on of the R&S NRP2. (see also SYSTem:
DATE on page 318).
The time is set in the format (h)h,(m)m,(s)s. This setting is not changed by *RST.
Parameter Value range
<hour> 0 to 24
<minute> 0 to 59
<second> 0 to 59
SYSTem:VERSion?
Returns a string that contains the current version number of the SCPI standard.
Usage:
Query only
6.15 TRIGger
The trigger commands are used to configure the timing conditions for the start of a mea-
surement.
When the sensors are connected to the R&S NRP2, they inform the device about the
SENSe and TRIGger commands supported and about the value ranges for parameters.
This applies to both numeric and text parameters. For this reason, no fixed ranges are
specified with these commands; the ranges can be obtained from the respective sensor
manual.
ABORt<[1]..4>...............................................................................................................325
ABORt:ALL....................................................................................................................325
INITiate<[1]..4>:CONTinuous..........................................................................................325
INITiate:ALL:CONTinuous...............................................................................................325
INITiate<[1]..4>:DISable.................................................................................................326
INITiate:ALL:DISable......................................................................................................326
INITiate<[1]..4>[:IMMediate]............................................................................................326
INITiate:ALL[:IMMediate]................................................................................................326
TRIGger:ALL:SYNChronize[:STATe]................................................................................327
TRIGger<[1]..4>:ATRigger[:STATe].................................................................................327
TRIGger:ALL:ATRigger[:STATe]......................................................................................327
TRIGger<[1]..4>:COUNt..................................................................................................327
TRIGger:ALL:COUNt......................................................................................................327
TRIGger<[1]..4>:DELay..................................................................................................328
TRIGger:ALL:DELay.......................................................................................................328
TRIGger<[1]..4>:DELay:AUTO........................................................................................328
TRIGger