R&S NRP2 - Page 341

Remote Control - Commands
R&S
®
NRP2
323User Manual 1173.9157.02 ─ 03
Parameters:
<state> NORMal | FAST
*RST: NORMal
SYSTem:STANdard:CATalog?
Returns a list of stored standards containing a series of strings separated by commas.
The strings can be used as parameters for theSYSTem:STANdard:PRESet
<string> command.
Usage: Query only
SYSTem:STANdard:PRESet <string>
The R&S NRP2 can be easily configured for measuring standardized signals (e.g. mobile
radio standards). For this purpose, the standards listed in the annex (chapter B, "Standard
Configurations", on page 365) are stored in the R&S NRP2. The SYST:STAN:PRES
command sets the listed parameters and, if desired, also configures front-panel display
windows (if SYST:STAN:PWS ON).
Parameters:
<string> The available standards and the associated strings can be queried
with the SYSTem:STANdard:CATalog command.
*RST: <empty_string>
SYSTem:STANdard:PWSettings <state>
If SYST:STAN:PRES <string> is used, SYST:STAN:PWS (Preserve Window Settings)
determines whether the window system is also configured with the calculate blocks
(OFF) or whether exclusively sensor parameters are set (ON).
Parameters:
<state> ON | OFF
*RST: OFF
SYSTem:STANdard:TRIGger:SOURce <source>
If SYST:STAN:PRES <string> is used, this command determines whether the sen-
sors are set to internal (INT) or external (EXT) triggering.
Parameters:
<source> INT | EXT
*RST: INT
SYSTem