R&S NRP2 - 8 Error Messages and Troubleshooting; Status and Error Messages in Manual Control

Error Messages and Troubleshooting
R&S
®
NRP2
335User Manual 1173.9157.02 ─ 03
8 Error Messages and Troubleshooting
8.1 Status and Error Messages in Manual Control
Special characters and symbols indicated on the display inform about the status of the
power meter, see chapter 3.6.2, "Special symbols", on page 58.
Symbols especially used for indicating error are:
●
The signal level is outside the set limit
●
A trigger event is required, but missing. To adjust the trigger settings, see chap-
ter 4.2.6, "Trigger settings", on page 85.
Invalid settings for trace display are indicated by an error message in the info panel.
Example: trace function 'Ratio' is selected but only one channel is active
A more detailed description of the error can be found in the "Trace Function" menu.
Status and Error Messages in Manual Control